1 6 Ways To Unclog A Bathtub Drain 2 1. Boiling Water 3 2. Fixing A Clogged Bathtub Drain Using A Plunger 4 3. Baking Soda and Vinegar 5 4. Manual Removal 6 5. Use A Plumbers Snake 6. Call A Plumber Frequently Asked Questions What Is The Best Way To Unclog A Bathtub? 1 6 Ways To Unclog A Bathtub Drain 0 1 6 Ways To Unclog A Bathtub Drain 1 1 6 Ways To Unclog A Bathtub Drain 2 An obstructed bathtub drain can be very annoying. Often, this problem is more difficult to resolve than a straightforward sink blockage, and you could feel overwhelmed by where to begin.

However, there are a number of straightforward DIY methods you can employ to clear the drain.

HOW TO UNCLOG A BATHTUB DRAIN: 6 STEPS We looked at six alternative approaches to clear a clogged bathtub drain. These can include DIY mixes, plumbing supplies, or phoning for assistance.

It’s recommended to begin with the simple steps and work your way up to the more challenging ones.

The fact that none of these treatments use chemical drain cleaners is crucial to notice. Despite their claims to remove obstructions, chemical drain cleaners are too corrosive for your pipes.

They may cause more harm than good, especially if improperly cleaned out or misused.

One of the first things you should try is boiling water, especially if you are unsure of what caused the clog. You can use your stove to heat water, then pour it down the bathtub drain.

Repeat the procedure as necessary to clear the clog if it appears to have done so until your tub is draining freely once more.
Shampoo and soap both respond nicely to this technique. Over time, soap scum can accumulate in layers, which in turn can lead to clogs.
Additionally, minor amounts of hair may cause soap scum to accumulate and clog your drain.

The greatest method for clearing clogs made of hair is not boiling water because it won’t dissolve matted clumps of hair. However, if the obstruction is mostly caused by soap, it may occasionally dissolve enough of the bulk to allow the hair to pass through the blockage unhindered.

2. USING A Plunger to Clear a Clogged Bathtub Drain

A must in every bathroom is a plunger. They are an essential tool for clearing drain obstructions.
You probably know plungers best for unclogging toilets, but did you know that they may also be used to unclog bathtub and sink drains?

Remember that plungers might not work as well in your bathtub as they do in your toilet. A shallow clog in the pipes is more likely to be removed by the plunging motion.

Take these actions:

Fill the tub with water To seal the plunger to the tub, apply petroleum jelly to its rim. Plunge the drain while doing so. Push the handle up and down quickly to generate strong suction that should help the obstruction be removed. When the tub’s water begins to drain normally, you will know the attempt was successful.

Purchasing a plunger just for your bathtub and sink is a smart investment. Toilet plungers frequently aren’t sanitary enough to use in other bathroom drains in addition to having a different form.



A tried-and-true combination to clean your pipes is baking soda and vinegar. While it lacks the same corrosive qualities as chemical cleaners, it shares many of the same dissolving capabilities.

Don’t combine the ingredients yourself. Do you recall the clay volcanoes your high school classmates used to construct?
For their eruption, those used vinegar and baking soda. You’ll have a huge mess in the end!
As an alternative, throw one cup of baking soda down the drain. Give it five minutes or so to settle.
After that, pour vinegar down. The two ingredients will combine to form a boiling froth that cleans the gunk from your pipes.
Finally, flush the residue away by pouring a saucepan of boiling water down the drain.
When dealing with minor obstructions, this approach works well. Hair mats are unlikely to disintegrate or be moved by it.


A bathtub clog can be manually removed, but you should never attempt this with a toilet obstruction. You should wear gloves to protect your hand and forearm because your drain is likely filthy.

Your drain cover needs to be unscrewed in order to be removed. Then illuminate the pipe with a flashlight.
Do you notice any debris, hair, or other obstructions? As much of the blockage as you can remove by reaching into the drain.
Once you’ve finished, you may put the drain cover back on and check the bathtub’s drainage by running some water through it.
5. Employ a plumbing snake

Despite their moniker, plumbers are not the only ones who can utilize snakes. They are available in a hardware store.

While a plastic drain snake might be useful for unclogging a clogged sink, it won’t bend well enough to fit the curve of the pipes in your tub. Find a motorized snake instead.

Frequently, the manufacturer will include usage instructions with the snake. The fundamental rules to adhere to are as follows:

Use a drop cloth to cover the tub’s bottom as protection. By doing this, the snake won’t unintentionally graze it. Unscrew the overflow plate to remove it. Insert the drain snake into the overflow drain’s entrance. Once you’ve pushed it as far as you can, lock it. Start clearing the clog by turning on the motor. The snake will handle the remaining task for you. Never attempt to insert a drain snake into the hole at the base of your bathtub. The snake won’t be able to pass through the bend because of how acute it is.

Your pipes could suffer significant damage.
Once the snake hits the obstruction, resistance will be felt. Run water through the tub if you believe you have cleared the obstruction.
Till the water drains normally, keep doing this.

It’s time to call a plumber if you’ve exhausted all DIY options and simple plumbing tools without success. Don’t give in to the need to buy chemical cleaners. The harm they might do is not worth it.

A plumber will be able to inspect your pipes, identify the source of the obstruction, and use their equipment to clear it. They can complete that procedure for you if utilizing a motorized drain snake makes you uneasy.

Any time a DIY project around the house is outside your area of expertise, it’s a good idea to consult a professional. This assists you in avoiding any mishaps and damage.

WHAT IS THE BEST METHOD TO UNCLOG A BATHTUB? IS OFTEN ASKED The location and type of the clog will determine the best method for clearing your tub.

For instance, it could be simplest to just shovel the dirt and debris out of the pipe for clogs that are close to the surface.
Boiling water is a useful initial option when dealing with obstructions caused by accumulated soap scum. It has the ability to remove soap scum.
If it doesn’t work, you can achieve a deeper clean by adding vinegar and baking soda inside the pipes.

You might require a motorized snake if the obstruction is truly impenetrable. The blockage will be penetrated by this instrument as it moves through the pipes and is pulled out.

HOW DOES STANDING WATER WORK TO UNCLOG A TUB? A clog issue can go from being an annoyance to becoming urgent if there is standing water. If you neglect a clog for a long time, which could eventually result in a total blockage of your pipes, you’re most likely to obtain standing water in your bathtub.

Standing water can develop mold and mildew and is unpleasant to stand in.

If there is water blocking your drain, you might be wondering how you can pour boiling water or vinegar down it. The solution is straightforward: You must drain the water.

Since you can’t use the drain itself for this, try scooping it out using buckets and cups. Then use a towel to absorb any leftover liquid.

Following this, you can use the other unclogging techniques described in this article.
WHERE CAN I FIND A HOME REMEDY TO UNCLOG MY BATHTUB? You can apply a few natural cures to unclog a clogged bathtub drain.
Water that is boiling is first. It’s simple enough to boil some water in a kettle or pot, then slowly pour it down the drain.

Baking soda and vinegar is the next option if boiling water is unable to clear the obstruction. You will pour more boiling water down the drain to wash the pollutants away once this mixture has cleaned the pipes.

CONCLUSION It can be challenging to unclog a bathtub drain, but it truly depends on the type of obstruction you have. Some clogs, such as surface blockages and soap scum, are quite simple to clear.

Others might need to be removed with the aid of experts or equipment like a motorized drain snake.





Enter your email address below to

subscribe to my newsletter