1 The Type Of Joint Compound You’ll Need 2 Material List For Patching Screw Holes 3 How To Patch Screw Holes In Drywall Step 1: Prepare the Face Paper Step 2: Butter Your Drywall Knife Step 3: Apply the First Coat Step 4: Apply the Second Coat Step 5: Sand Rough Spots Down 4 Conclusion There are probably a few small holes in your wall if you’ve recently removed drywall anchors or hung pictures with screws.
Even if you’re a complete novice, you can mend these holes even though they are a pain.
You must fill the holes with a pre-mixed joint compound if you want to mend screw holes in drywall. Typically, two layers of compound are required for effective mending, followed by a little sanding.
You should also be aware of the following.
WHAT KIND OF JOINT COMPOUND WILL YOU NEED? There are numerous varieties of drywall mud available. However, a tiny pale of pre-mixed joint compound is your best bet if you simply need to patch one or two screw holes.
For filling up your walls, pre-mixed all-purpose joint compound has the ideal consistency.
Instead of covering bigger screw holes, use spackle to conceal extremely small nail holes. Similar to joint compound but lighter and excellent for small holes is spackle.
PATCHING SCREW HOLE MATERIALS LIST To patch drywall screw holes, you’ll need the following materials:
drywall knife or putty knife, 4 inches Useful knife All-purpose joint compound already prepared Printed towels Sanding sponges or paper with a fine grit PATCH SCREW HOLES IN DRYWALL: DIRECTIONS
Prepare the face paper in step one. The area surrounding the hole must be clean and free of frayed face paper before you can fill it. Sometimes, all it takes to repair this is a gentle tap with the handle of your drywall knife on the edge of the hole to make it concave.
Trim the face paper if tapping the holes doesn’t result in a clean result.
Peel the paper from the wall after gently cutting around the edges. Next, check the area with your hand to see if it is smooth.
BUTTER YOUR DRYWALL KNIFE IN STEP 2 To coat the front edge of the blade with compound, dip your drywall knife into the joint compound. Wipe with a paper towel if anything is protruding from the sides or hanging off.
Keep your knife from getting too much muck on it. A huge mess will result from this.
Apply the first coat in Step 3 Now turn the mud-covered knife toward the wall. Fill the hole with joint compound by running the knife over it. (Repeat this step if the area contains divots.)
Next, merely run your knife over the hole perpendicularly this time. Any high places will be flattened by doing this.
After applying the initial coat, give the joint compound time to completely dry. This typically takes 1-2 hours for small screw holes, but you can check the joint compound bottle for an exact drying time.
Apply the second coat in step four. The joint compound shrinks and occasionally breaks as it dries. As a result, the screw holes will require a second coat.
Applying a second coat is as simple as repeating the previous coat’s procedures. Just make sure the coating is extremely thin.
SAND ROUGH SPOTS DOWN IN STEP 5. When the second layer is completely dry, softly sand the surface using a fine-grit sanding sponge. Sand the surface until it’s smooth, then use a fresh rag to remove any dust.
CONCLUSION Filling in screw holes in drywall is not too difficult. Even if you’ve never repaired drywall yourself, you should be able to do it.
To make the process as simple as possible, use an all-purpose joint compound that has been pre-mixed. A wall that is smooth and hole-free will be achieved with two coats of compound and light sanding.
